Hi Friends,tv had flash-over in isolation off orega 40351A-5 I changed
by HR 80001( found in HR site)
FAULT: by ON all voltages reach immediatel the exact value as mention
on schematic!Very high tension ,Uvideo=196v etc ok ,heater ok (burning)
BUT nothing to see or hear,red led blinking 1 X and once more
1X...short interval and 1 X...and 1X once more..at this moment sound
and image are there ( both normal in every way)
Any idea? Best regards Alfons
TV [fault] thomson 29DX/ETC 210
-
-
nur soviel hier wird Deutsch geschieben.
Andreas
-
Andreas! Bei Fuß!!! Los, sofort!
Hast Du mal die Überschrift gelesen? "English area" Was mag das wohl heissen?
Sorry Alfons, these posts are a mistake.
-
es ist dir wohl nicht entgangen das ich ein etwas älterer Jahrgang bin
und mit English nicht so vertraut bin.tcfkat Was mag das wohl heissen?
keine Ahnung klär mich auf aber bitte bitte auf Deutsch.
bei Fuß mit dieser Aussage kann ich nichts anfangen.Andreas
²Die Natur verbirgt ihr Geheimnis durch die Erhabenheit ihres Wesens, aber nicht durch List."
-
Schade das wir keine Moderatoren haben.
Lasst bitte den Blödsinn hier
-
I think the TDA 8177 is defective (vertical output stage) check the seafetyresistors near the IC
is it an ICC 20?best regarts Video6